Linux Tips, Hacks, Tricks, and Tutorials
Sample code : #include “SIM900.h” #include //#include “inetGSM.h” //#include “sms.h” //#include “call.h” //To change pins for Software Serial, use the two lines in GSM.cpp. //GSM Shield for Arduino //www.open-electronics.org //this code is based on the example of Arduino Labs. //Simple sketch to communicate with SIM900 through AT commands. //InetGSM inet; //CallGSM call; //SMSGSM sms; int […]
How to Create a New User Let’s start by making a new user within the MySQL shell: CREATE USER ‘newuser’@’localhost’ IDENTIFIED BY ‘password’; Sadly, at this point newuser has no permissions to do anything with the databases. In fact, if newuser even tries to login (with the password, password), they will not be able to […]
This is a useful command when building your dial plan, it allows testing of the dial plan remotely. There are a couple of commands to explain. The first is the originate command a highly useful tool for checking any IVR context’s, this is how to use it. originate SIP/14075551234@sip-outbound extension s@auto-att Let me explain this.: […]
This HOWTO assumes that your FreePBX system is sitting behind a NATed firewall with no direct connection to the outside world and it is NOT in the DMZ zone. If you have your system facing outside, or have used Mapped IP addresses or other techniques, then it is assumed that you have adequate knowledge to […]
NAT issues Perhaps the most common problem encountered is one-way audio, and 99% of the time, this is caused by a NAT firewall. So here are the steps you must take to configure the PBX to work behind a NAT firewall. Make sure you have a resolvable address on the Internet. If you don’t want […]
On Asterisk /etc/asterisk/sip.conf, you need to configure the account exactly similar to User ID of SPA400 The entries in sip.conf to enable Asterisk register to SPA400 are as follow: [general] register => 9000@192.168.0.6/9000 Replace 9000 with the value you entered in the User ID of SPA400, and replace 192.168.0.2 with the IP address of the […]
This sketch receives a voice call from an Arduino or Genuino board equipped with a GSM shield. Once the call is received and connected, it shows the number that is calling, and hangs up. You’ll need to attach a speaker and microphone to hear the connected call and transmit your voice. Hardware Required Arduino or […]
This article will help you to install and configure Webmin on CentOS, RHEL and Fedora systems. Kindly go through below steps. At the time of last update of this article Webmin 1.780 is the latest available version to download and install. Download Webmin RPM Webmin rpms are available on its official site. Download it from […]
Server 1 configurations [usa-IAX] host=10.0.0.1 username=panadura secret=RMoBaNvjZO type=peer qualify=yes context=from-trunk-iax2-usa-IAX [usa-IAX_user] secret=RMoBaNvjZO type=user context=from-internal Server 2 Configurations [panadura-IAX] host=10.0.0.1 username=panadura secret=RMoBaNvjZO type=peer qualify=yes context=from-trunk-iax2-panadura-IAX [panadura-IAX_user] secret=RMoBaNvjZO type=user context=from-internal
A common problem is that WordPress is unable to access the filesystem directly, which results in a page indicating that “To perform the requested action, connection information is required.“ What Can I Do About It? In order to fix this issue, you will need to make sure that the scripts which need to write to […]