Related Articles
Let’s Encrypt SSL for GitLab
To enable Let’s Encrypt SSL for GitLab, follow these steps. Ensure that GitLab is configured properly and you have root access to your GitLab instance. The steps apply to GitLab’s Omnibus installation. 1. Ensure Prerequisites A publicly accessible domain name pointing to your GitLab server. Port 80 (HTTP) and port 443 (HTTPS) open on your […]
Gitlab reset Password for root
You will need to do the following: SSH into your Droplet where GitLab is installed. ssh [your-user]@[your-droplet-ip-address] Open the GitLab Rails console. If you installed GitLab via the Omnibus package, you can open the Rails console with: sudo gitlab-rails console Locate the root user and change the password. Once in the console, enter the following commands: user = […]
Howto setup Asterisk behind NAT
This HOWTO assumes that your FreePBX system is sitting behind a NATed firewall with no direct connection to the outside world and it is NOT in the DMZ zone. If you have your system facing outside, or have used Mapped IP addresses or other techniques, then it is assumed that you have adequate knowledge to […]